Good evening at all , someone could explain how to use digilines and node detectors ?
For example:
Let the node detector communicate with the lcd screen....
thank you all
node detector and digiline
-
- New member
- Posts: 4
- Joined: Mon Jul 30, 2018 19:55
Re: node detector and digiline
I know it's been ages. I was looking for the same information and had to go to the source code to figure it out.
First, this is the only block I've found so far that only takes GET in uppercase. I'll assume the player detector has the same defect since it has the same code base.
1) Place the Node Detector and set it's Digiline name.
2) Send digiline_send("nodedetector_name_you_set","GET") -- UPPERCASE GET ONLY
3) Response has what you're looking for.
4) If you digiline_send("nodedetector_name_you_set","default:air") it will set the name of the item the detector is looking for.
Hope this helps.
if event.type == "interrupt" or event.type == "program" then
digiline_send("test","GET")
interrupt (10)
end
print (event)
First, this is the only block I've found so far that only takes GET in uppercase. I'll assume the player detector has the same defect since it has the same code base.
1) Place the Node Detector and set it's Digiline name.
2) Send digiline_send("nodedetector_name_you_set","GET") -- UPPERCASE GET ONLY
3) Response has what you're looking for.
4) If you digiline_send("nodedetector_name_you_set","default:air") it will set the name of the item the detector is looking for.
Hope this helps.
if event.type == "interrupt" or event.type == "program" then
digiline_send("test","GET")
interrupt (10)
end
print (event)
Who is online
Users browsing this forum: No registered users and 32 guests