alpha channel of textures not working properly, do not use the full range for the value of transparency, however it works perfectly in inventory...
ideally is, who uses a range of 16 shades, minimum
transparency applies only to values below 50%, and if applied in overlapping textures (such as minerals and stone), an alpha with halftones, event of such interference with the block ...
This has a solution?
alpha channel of textures not working
alpha channel of textures not working
My mod: [MOD]3D Forniture 1.0
Download: 3DForniture_v_1.0.zip
Page development (European Castilian):
Moviliario 3D (proyecto 3D Forniture)
Download: 3DForniture_v_1.0.zip
Page development (European Castilian):
Moviliario 3D (proyecto 3D Forniture)
The problem MAY be more difficult than you imagine. Although I don't see a problem in your case, since it is an overlapping texture. This may be the cause:
In openGL, when you have 2 overlapping surfaces, it will determine which one should be on top using a technique called the depth buffer. However, the depth buffer does not work that well with transparency. That is why usually the non-transparent parts are drawn first. Then the transparent parts are drawn and then the HUD (inventory, menu's, etc).
There are solutions but it will require more of the cpu or look far uglier.
In openGL, when you have 2 overlapping surfaces, it will determine which one should be on top using a technique called the depth buffer. However, the depth buffer does not work that well with transparency. That is why usually the non-transparent parts are drawn first. Then the transparent parts are drawn and then the HUD (inventory, menu's, etc).
There are solutions but it will require more of the cpu or look far uglier.
We must be careful not to clone Notches mistakes.
That might explain the trick ...
but
why not accept images with alpha channels over "1 bit" deep?
but
why not accept images with alpha channels over "1 bit" deep?
My mod: [MOD]3D Forniture 1.0
Download: 3DForniture_v_1.0.zip
Page development (European Castilian):
Moviliario 3D (proyecto 3D Forniture)
Download: 3DForniture_v_1.0.zip
Page development (European Castilian):
Moviliario 3D (proyecto 3D Forniture)
great!!
but that can not be changed from minetest.conf
That sounds like dangerous territory for a infographics artist ...
but that can not be changed from minetest.conf
That sounds like dangerous territory for a infographics artist ...
My mod: [MOD]3D Forniture 1.0
Download: 3DForniture_v_1.0.zip
Page development (European Castilian):
Moviliario 3D (proyecto 3D Forniture)
Download: 3DForniture_v_1.0.zip
Page development (European Castilian):
Moviliario 3D (proyecto 3D Forniture)
Who is online
Users browsing this forum: No registered users and 10 guests